Xirgo Global
Chemijos st. 15 LT-51332, Kaunas, Lithuania
www.xirgoglobal.com
2.
Annex 1. Installation instructions
General
Central unit is only mounted in inside of the vehicle, it can not be installed in the engine chamber,
next to the cabin, or in the area of exposure to direct external conditions. Central unit should be protected
from moisture exposure. Device must be fastened in a stable position to avoid random twitches and
displacements (suspension on cables is strictly prohibited). Central unit must be mounted horizontally.
Precise orientation is of particular importance to flawless operation of the system, since the device is
equipped with acceleration sensors recording the data which directly affects the results obtained.
List of suitable vehicles
FMS500 LIGHT+ SDK is intended for internal combustion engines, hybrid and electric
engines, where power supply specifications are met. Device must be connected to the vehicle battery,
ensuring constant power supply even if the engine is not working and ignition is off.
Basic instructions before beginning the installation
Quality of connections, location of the device, etc. play a significant role on accurate operation of the
system. Below are some tips and rules for correct installation to attain professional quality and ensure
maximum efficiency of the device.
Mechanical connections
To highest possible extent, cavities in the vehicle should be used for wiring. If you need to make a
new hole, it must be protected against corrosion appropriately!
Wiring connection must be made by brazing, and not merely mechanical wire connection. It is
especially important to protect the connections with insulation for high-resistance atmospheric
conditions. Do not use insulation with unknown resistance parameters.
Efforts should be made to tie the new wiring into the car's standard wiring bales.
