Wireless Access Point
556
Non-Modification Statement
Unauthorized changes or modifications to the device are not permitted. Use only
the supplied internal antenna, or external antennas supplied by the manufacturer.
Modifications to the device will void the warranty and may violate FCC
regulations.
Cable Runs for Power over Ethernet (PoE)
The AP must be connected to PoE networks without routing cabling to the
outside plant — this ensures that cabling is not exposed to lightning strikes or
possible cross over from high voltage.
Battery Warning
UL Statement
Use only with listed ITE product.
Industry Canada Statement (XA, XD Series)
This device complies with Industry Canada license-exempt RSS standards (RSS
247), and standards for Digital Transmission Systems (DTSs), Frequency Hopping
Systems (FHSs) and License-Exempt Local Area Network (LE-LAN) Devices.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
!
Caution!
The AP contains a battery which is not to be replaced by the customer.
Danger of Explosion exists if the battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
