Wireless Array
Installing the Wireless Array
67
3.
Alternatively, you may query the Array using the CLI via the serial port.
Log in using the default user name
admin
and password
admin
. Use the
show ethernet
command to view the IP addresses assigned to each port.
Starting the WMI
Use this procedure to log in to the WMI via your Web browser.
1.
Establish a network connection and open your Web browser.
2.
Connect to the Wireless Array using its host name or IP address as
described in the previous section.
Logging In
When logging in to the Array, use the default user name and password — the
default user name is
admin
, and the default password is
admin
.
See Also
Installation Workflow
Performing the Express Setup Procedure
Powering Up the Wireless Array
Entering the License
A license is needed to operate the Wireless Array at full functionality. Without a
license, the Array may only be powered up and have a basic network
configuration.
The Array’s license determines many of the features that are available on the
Array. For example, automatic cell sizing and channel allocation require a license
supporting the RF Performance Manager (RPM). Also, IEEE 802.11n operation on
XN model Arrays requires a license.
The Array’s license is not installed at the factory.
You must enter your license
before proceeding to the next step
,
Performing the Express Setup Procedure
.
The procedure below describes entering the license key using the WMI. If you are
using the Xirrus Management System (XMS), you may use it to easily manage and
upgrade large numbers of licenses for the wireless network.
