Safety Instructions
1. Always read the safety instructions carefully.
2. Keep this user’s manual handy for future reference.
3. Do not keep this equipment in a humid environment.
4. Place this equipment on a stable flat surface before setting it up.
5. The vents in the case are for air movement which protects the
equipment from overheating. DO NOT COVER THE VENTS.
6. Check power adapter rating: 19V 3.42A, Max 65W.
7. Verify the voltage of the power supply and adjust to 110-240V
before connecting the equipment to the power socket. Rating: 100-240V, 50-
60Hz, 1.7A.
8. Place the power cord in such a way that people can not step on it. Do not place
anything over the power cord.
9. Always unplug the power supply before inserting any add-on card or module.
10. All cautions and warnings on the equipment should be noted.
11. Never pour any liquid into the opening that could damage or cause electrical
shock.
12. If any of the following situations arises, get the equipment checked by
service personnel:
•
The power cord or plug is damaged.
•
Liquid has penetrated into the equipment.
•
The equipment has been exposed to moisture.
•
The equipment does not work well or you can not get it work according to
•
user’s
manual.
•
The equipment has dropped and damaged.
•
The equipment has obvious sign of breakage.
13. KEEP THIS EQUIPMENT AT AN AMBIENT AIR TEMPERATURE BELOW 40ºC (102ºF),
TO PREVENT DAMAGE TO THE EQUIPMENT.
WARNING:
1. If you use a different power cable, please use an approved power
cord with condition greater or equal to H05VV-F, 3G, 0.75mm
2
.
2. Contains hazardous moving parts; please keep fingers and other body
parts away.
3. For pluggable equipment, the socket-outlet shall be installed near the equipment
and shall be easily accessible.
4. Do not disable the protective earth pin from the plug, the equipment must be
connected to an earthed mains socket-outlet.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer.
廢電池請回收
For better environmental protection, waste batteries should be
collected separately for recycling or special disposal.
1. The optical storage devices are classified as a Class 1 Laser products. Use of controls or
adjustments or performance of procedures other than those specified.
2. Do not touch the lens inside the drive.
FCC-B Radio Frequency Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the measures listed below:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
WEEE (Waste Electrical and Electronic Equipment) Statement
Under the European Union (“EU”) Directive on Waste Electrical and Electronic Equipment,
Directive 2002/96/EC, which takes effect on August 13, 2005, products of “electrical and
electronic equipment” cannot be discarded as municipal waste anymore, and
manufacturers of covered electronic equipment will be obligated to take back such
products at the end of their useful life. XiVA will comply with the product take back
requirements at the end of life of XiVA-branded products that are sold into the EU. You can return
these products to local collection points.
•
Consult the dealer or an experienced radio/television technician for help.
Notice 1
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Notice 2
Shielded interface cables and A.C. power cord, if any, must be used in order to
comply with the emission limits.
VOIR LA NOTICE D’INSTALLATION AVANT DE RACCORDER AU RESEAU.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
.
Summary of Contents for music M8
Page 1: ...4...
