9
Load the camera and the frame
First of all,please fix the camera frame by using M3X6 inner hexagonal screw.
Load the camera into the camera case and then fix it by using the self-spinning screw.
Load the camera case into the camera frame by the self-spinning screw.Adjust the angle of the
camera according to your own requirement. When the angle has been confirmed by you,please
lock tightly by the self-spinning screw.
Caution:
1.This camera hanging rack only can be used for XK brand standard and Gopro 3.It can not
be loaded any other cameras in the market.
2.When using Gopro 3 camera,you can not open the WIFI as they are all 2.4G ,which may bring
big interference to the quadrocopter and cause flying accident.
Trim the control lever of the transmitter
It can reduce or resolve the discrepancy when operating the control stick ,which helps enhance
the accurate control operation.
Switch on the transmitter and load the batteries into the quadcopter,wait until the self-decoding
is finished and the red and green light will be flashing slowly.
Pull the throttle lever to the lowest position and then the direction lever to the right side,
successively pull the auto-return switch for 6 back and forth,the signal will turn from red light
eternal ON to quick flashing red light. Quickly pull the control levers on both sides for one circle
so as to reach the maximum of minimum position.
Release the joystick to let the control stick return to the middle position , the red light will turn
from quick flashing into red and green light slow flashing or green light slow flashing (with
GPS),this time the triming is successfully finished.
