Notice:
Never attempt to charge the battery direct from a wall socket without using the
supplied wall charger.
1-cell 3.7V variable rate DC LiPo charger Instructions:
Only charge with the supplied XK LiPo charger, never charge the LiPo battery
unattended.
1. Plug the charger into the wall socket.
2. Plug the Lithium Polymer battery plug into the charger jack, as shown in figure below.
3. Turn on the wall socket.
4. The Charge LED indicator will change to Red to show the battery is charging.
5. When fully charged the charge indicator on the charger will change to Green.
1. Make sure the battery is fully charged.
2. Before connecting the battery make sure the throttle control stick is positioned
downwards and the right control stick is in the centre.
3. If you are flying two quadcopters in the same location and experience problems turn
one off and turn back on to rebind on a different frequency following the “Binding of
transmitter and receiver” instructions.
4. Look for a suitable location to fly, away from crowds, cars, high-voltage towers,
reservoirs, etc. Make sure you are safe and enjoy your flying.
