TORPEDO SYSTEM 50
AERODYNAMIC ACCESSORIES
STEP 1 MINI MOUNT AND CAGE ATTACHMENT
1.
REMOVING BOTTLE
. Hold Mount and twist bottle clockwise, lift nose and pull bottle forward and
out of the cage.
Figure (A)
2.
POSITIONING CAGE AND MINI MOUNT
. Ensure the rear screw is as at the rear of the cage and in the rear of the slot in the Mount
Figure (B)
.
Tighten the screws to 30 in lbs of torque. (3.4 Nm)
.
3. Thread a strap up through the Mount with the logo facing outwards. Pass the strap over the aero bar and
through the buckle and attach loosely. Rotate so buckle is under the aero bar.
4.
ATTACHING MOUNT
. Lay the Mount onto the aerobars. Position the rear straps as far back on the bars as possible. If any parts of the
mount or screws touch the stem, then add the Velcro Pads to the mount. Thread straps through buckles and tighten.
Figure (C)
5.
FINAL STRAP TIGHTENING
. The non-slip silicone on the straps should be touching the aerobars. Center the Mount and
tighten opposite straps. Then go back and re-tighten all straps to ensure all straps are as tight as you can get them.
Make sure that the reinforced (double thickness) section of the polyester straps are in the slot on the
TORPEDO MINI MOUNT
.
Figure (D)
Figure (A)
Figure (C)
Figure (B)
Figure (D)
Shows threading of the straps
INTERMEDIATE KIT INSTRUCTIONS
INTERMEDIATE KIT INSTRUCTIONS
IMPORTANT:
PLEASE COMPLETELY UNDERSTAND ALL USER INSTRUCTIONS AND SAFETY INFORMATION BEFORE USING THIS PRODUCT. AS WITH ANY HIGH TECH PRODUCT YOU WILL NEED
TO ROUTINELY CHECK FOR LOOSE HARDWARE, CRACKS OR OTHER DAMAGE AND REPLACE ITEMS AS NECESSARY. DO NOT USE PRODUCT IF ANY OF THESE CONDITIONS EXIST.
TOOLS REQUIRED:
4mm non-ball ended Allen wrench.
8mm open ended wrench.
Figure (F)
STEP 2 BOTTLE INSTALL
1.
EASY INSTALL
. Push bottle rearwards, ensuring the rear tab of the cage slides into the rear bottle recess. Next ensure the
rear cage screw head clicks into the long recess on the bottom of the bottle.
The rear cage tab should now sit against the
vertical surface inside the back of the bottle.
Figure (E)
2.
LID INSTALL
. The lid has a tether hole. Put the straw through this hole to avoid losing the lid when refilling.
3.
STRAW INSTALL
. Determine which hole is best suited for you. Install the plug in the other hole from the inside of the bottle.
Start the plug at an angle and push up around the perimeter of plug. Ensure the top of the plug is completely through the
hole. The straw is designed to fit tightly in the straw hole to prevent leaking. To best insert the straw, pinch and fold the
end of the straw while pushing it into the hole. For the straw to be vertical, tuck the end of the straw behind the groove
in the bottom of the bottle.
Figure (F)
After each ride, gradually trim the straw to your optimum length.
Figure (E)
C
M
Y
CM
MY
CY
CMY
K
