31
Bicycle Computer
32
Clear The Measured Value For Average Cadence, Maximum Cadence, Trip
Cadence At The Same Time
Clear All The Measured Value Except ID Codes by DEFAULT SETTING
Under TRIP CADENCE, press
C
key for 2 seconds
(AVERAGE CADENCE, MAXIMUM CADENCE, TRIP CADENCE will return to
zero.)
Under STOPWATCH MODE, press and hold all
M
S
C
keys at the same time
for 6 sec until all the values return to default values.
The default setting will keep the ID Code and the Clock after all the default
values.
ID Scan for Coded Speed
Chapter 7
The advange of 2.4Ghz wireless transmitting technology is stablized signals
from the chest belt or speed sensor to the cycle computer. CY533AC can avoid
noise interference from other devices while it is working with speed sensor.
Each device and sensor has been ID SCAN after manufacturing.
So the user can start to use the product immediately without doing ID SCAN.
The main purpose of ID SCAN is to pair up the cycle computer to its speed/
cadence sensor as well as to prevent signals and cross talk from other cycle
computers. Each cycle computer set has been pre-ID Scan right after it’s
produced, so the users do not necessarily need to run ID-SCAN after their
purchase. The users would need to run ID-SCAN as if additional speed/cadence
sensor are being replaced or for purpose of second bike uses.
NOTE
The BIKE1&BIKE2 can coordinate with one individual code from one speed sensor or two
individual codes with additional speed sensor, chest belt respectively.
Under any mode, press
A
key and
C
key at same time for 6 sceonds.
When the percentage of shows 100% means scan completed.
(Please note that speed sensor have to be in wake up mode)