Your XLH PHASE comes with a LiPo battery. The rechargeable Li-Po
battery provides the power to propel your model at high speeds. You
should expect 5-8 min run time. However you do need to make sure to
properly maintain your Li-Po Battery.
- Li-Po batteries don’t like to be run down too low. If the voltage is
dropped dramatically they will be damaged and will not recharge! Once
the model starts to slow, drive your model to a safe place, walk over and
turn it off.
- It is recommend to charge the battery after your run and to always store
the battery with a charge. Never discharge or dead short a Li-Po battery!
Always unplug the battery from the model when not in use.
1/ Carefully remove the battery from the rear of the quadcopter.
2/ Plug the USB into your computer, TV, or USB charger. The LED light on
the USB will turn RED.
2/ Plug the other end of the cable into your XLH PHASE battery. Do not
force the plug, it only goes in one way. The LED light on the USB will turn
OFF.
3/ Charge time can take up to 60 minute (shorter if charging for the first
time). Once charged the LED light on the USB will turn back on to RED.
Tip: If storing for more than 24 hours it is best to store with a fully
charged battery. Failure to do so can damage the battery pack and
shorten its useful life.
- Always remove the battery from the toy for charging.
- Unplug the battery from the toy if storing for more than 24 hours.
How to charge the XLH PHASE:
Forward Flip:
Hold the right stick
forward once and your
PHASE will do a forward
flip.
Right Flip:
Hold the right stick to
the right once and your
PHASE will do a right
flip.
Left Flip:
Hold the right stick to
the left once and your
PHASE will do a left flip.
Backward Flip:
Hold the right stick
backwards once and
your PHASE will do a
backward flip.
