17
Oven Assembly
XLT ovens can easily be moved and stacked with the proper lifting equipment. The use of
lifting equipment is highly recommended.
WARNING & SAFETY INFORMATION
Base Assembly - Triple Stack
1. Flip the oven base upside down on the floor.
2. For triple-stack configurations, attach the four casters directly to the base with the supplied
3/8" x 1" hex bolts, washers, and lock-washers.
3. Flip the base assembly over and ensure the insulation is placed properly.
These ovens are heavy and can tip or fall causing bodily injury.
NEVER place any part of your body beneath any oven that is suspended by the
lifting jacks. A crush hazard exists if the oven falls or slips.
DO NOT place your hands on the lifting jack vertical pole beneath the jack’s
winch. As the jack’s winch descends when you turn the jack handle, a pinch
point is created between the winch and the pole.
WARNING
BE CAREFUL when rolling the oven on the cart, especially when going up or down
ramps and over bumps. Leave the straps/banding on until the oven is near the assem-
bly area.
CAUTION
Summary of Contents for 1832-AE-B
