XD-9010-TS3-W-EN Rev A 04/2009
Installation & Operation Manual
10
3. OPERATION
The XLT oven is a convection oven. It cooks foods by forcing hot air to circulate around the food,
thereby increasing the heat transfer rate. Convection ovens generally cook foods faster than
conventional ovens. The XLT oven models also have a conveyor that carries food through the oven at
a uniform rate. This helps eliminate under or over cooking food.
3.1. CONDENSED START-UP INSTRUCTIONS
3.1.1. FOR THE 1832-TS3-W, 2440-TS3-W, 3240-TS3-W,
3255-TS3-W AND 3855-TS3-W MODELS
1.
Turn the OVEN switch ON (see Figure 5), fan will start automatically.
2.
Adjust the temperature controller set-point to the desired temperature (see Figure 6).
3.
Observe the indicated temperature for one minute. You should hear the burner ignite and the
temperature should rise after 30-45 seconds.
4.
If the burner does not ignite, turn the OVEN switch OFF, wait FIVE (5) minutes, and repeat
steps 1 & 3.
5.
Push the ENTER KEY button twice to start conveyor, if not already running, (see Figure 6).
6.
Adjust the conveyor controller to desired belt time (see Figure 6).
7.
Allow about 30 minutes for the oven to reach desired operating temperature.
This oven is not capable of being safely placed in operation in the event of a power failure. No
attempt should be made to operate this oven during power failure.
3.1.2. FOR THE 3270-TS3-W AND 3870-TS3-W MODELS
1.
Turn OVEN switch ON (see Figure 5).
2.
Adjust both of the temperature controller set-points to the desired temperatures (see Figure 6
& Figure 7).
3.
Observe the indicated temperature for one minute. You should hear the burners ignite and
both of the temperatures should rise after 30-45 seconds.
4.
If one or both of the burners do not ignite, turn OVEN switch OFF, wait FIVE (5) minutes,
and repeat steps 3 & 4.
5.
Push the ENTER KEY button twice to start conveyor, if not already running, (see Figure 6).
6.
Adjust the conveyor controller to desired belt time (see Figure 6).
7.
Allow about 30 minutes for the oven to reach desired operating temperature.
This oven is not capable of being safely placed in operation in the event of a power failure. No
attempt should be made to operate this oven during power failure.
