1
XD-9010-TS3-W-EN Rev A 04/2009
Installation & Operation manual
WARNING & SAFETY INFORMATION
•
Post in a prominent location instructions to be followed in the event you smell gas. This information
can be obtained by consulting your local gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable
liquids or vapors in the vicinity of this or any other appliance.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury, or death. Read the installation, operating and maintenance instructions
thoroughly before installing, using, or servicing this equipment.
•
In the event a gas odor is detected, shut off the gas at the main shutoff valve immediately. Contact
your local Gas Company or supplier.
•
Do not restrict the flow of combustion and/or ventilation air to the unit. Provide adequate clearance
for operating, cleaning, and maintaining the unit and adequate clearance for operating the gas shutoff
valve when the unit is in the installed position.
•
Keep the area free and clear of combustible material. DO NOT SPRAY AEROSOLS IN THE
VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION.
•
Ovens are certified for installation on combustible floors.
•
An electrical schematic is located inside the control box of the oven and on pages 32-34 of this
manual. Disconnect input power to the unit before performing any maintenance.
•
This unit requires a type II ventilation hood, which has make-up and exhaust air to ensure adequate air
supply. The installation should conform to local codes.
•
This unit may be operated with either natural gas or LP fuel as designated on the nameplate label
located on the side of the unit.
•
This unit must be operated by the same voltage, phase, and frequency of electrical power as
designated on the nameplate label located on the side of the unit.
•
Minimum clearances must be maintained from combustible and noncombustible construction
materials. See Physical Location & Spacing Information on page 20.
•
Follow all local codes when installing this unit.
•
Follow all local codes to electrically ground the unit.
•
Appliance is not to be cleaned with a water jet.
•
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
