XD-9010-TS3-S Rev A 04/2009
Installation & Operation Manual
1
WARNING & SAFETY INFORMATION
•
Post in a prominent location instructions to be followed in the event you smell gas. This information
can be obtained by consulting your local gas supplier.
FOR YOUR SAFETY
Do not store or use gasoline or other flammable
liquids or vapors in the vicinity of this or any other appliance.
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury, or death. Read the installation, operating and maintenance instructions
thoroughly before installing, using, or servicing this equipment.
•
In the event a gas odor is detected, shut off the gas at the main shutoff valve immediately. Contact
your local Gas Company or supplier.
•
Do not restrict the flow of combustion and/or ventilation air to the unit. Provide adequate clearance
for operating, cleaning, and maintaining the unit and adequate clearance for operating the gas shutoff
valve when the unit is in the installed position.
•
Keep the area free and clear of combustible material.
•
Ovens are certified for installation on combustible floors.
An electrical schematic is located inside the control box of the oven and on pages 31-33
of this manual. Disconnect input power to the unit before performing any maintenance.
•
This unit requires a type II ventilation hood, which has make-up and exhaust air to ensure adequate air
supply. The installation should conform to local codes and the National Fire Protection Association
Code, ANSI/NFPA 70, and the National Electrical Code.
•
This unit may be operated with either natural gas or propane fuel as designated on the nameplate label
located on the back of the unit.
•
This unit must be operated by the same voltage, phase, and frequency of electrical power as
designated on the nameplate label located on the back of the unit.
•
Minimum clearances must be maintained from combustible and noncombustible construction
materials. See Physical Location & Spacing Requirements on page 19.
•
Follow all local codes when installing this unit. In the absence of local codes, the installation must
conform to the National Fuel Gas Code, ANSI Z223.1, latest version, Natural Gas Installation Code,
CAN/CGA-B149.1, or the Propane Installation Code, CAN/CGA-B149.2, as applicable.
•
Follow all local codes to electrically ground the unit. The installation must conform to the National
Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2, as applicable.
•
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
