XD-9010-TS3-S Rev A 04/2009
20
Installation & Operation Manual
5.7. CASTERS
Because the oven(s) are equipped with casters, the installation must be made with a connector
that complies with the Standard for Connectors for Moveable Gas Appliances, ANSI Z21.69 or
Connectors for Moveable Gas Appliances CAN/CGA-6.16, and a quick-disconnect device that
complies with the Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI Z21.41,
or Quick-Disconnect Devices for Use With Gas Fuel, CAN1-6.9.
5.8. RESTRAINT
For all installations, a restraint must be provided to limit the movement of the oven without
depending on the gas connector and the quick-disconnect device or its associated piping, and/or
the electric cord, to limit the oven movement. One restraint required per oven stack. The
restraint must be connected to the eye bolt which is supplied with the oven. The eye bolt is in the
lowest hole in the back wall on the control end of the lowest oven in the stack. Upon completion
of performing any service functions that require removal of the restraint, insure that it is correctly
re-attached to the oven (see Figure 13). One restraint is required per oven stack.
Figure 13: Restraint view
5.9. VENTILATION
5.9.1. VENTILATION REQUIREMENTS
Most gas burning appliances produce carbon monoxide, a poison. This and the heat generated
must be vented to the outside. A ventilation hood is required to remove the heat and products of
combustion. The hood and HVAC installation must meet local building and mechanical codes.
