32
33
5
Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console . Coil any excess
cable in a hidden location, such as under the carpet, keeping it away from
any vehicle pedals or controls . Secure the excess cable with wire ties
(purchased separately) .
6
Bring the end of the cable out at the PowerConnect Vehicle Dock location .
Leave yourself enough cable so you can easily connect it to the antenna
connector of the dock .
7
Continue with “Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter” on page 37 .
Sedan/Coupe With Antenna Placed at the Front of the Roof
1
Feed the antenna cable from the antenna underneath the rubber molding
around the windshield . Use a blunt plastic putty knife or similar blunt tool
to lift the rubber molding around the windshield and tuck the antenna
cable underneath the molding . Route the antenna cable around and down
the windshield to the lowest point .
2
At the lowest corner of the windshield, route the cable out of the
windshield molding and into the rubber weather stripping around the
door opening . Lift the weather
stripping from the opening and
tuck the cable inside it, then
replace the weather stripping .
Run the cable inside of the
weather stripping to the bottom
of the door opening .
3
Pull the cable out of the
weather stripping at the bottom
of the door opening and route it under the carpet toward the dashboard .
Coil any excess cable in a hidden location, such as under the carpet,
keeping it away from any vehicle pedals or controls . Secure the excess
cable with wire ties .
4
Bring the end of the cable out at the PowerConnect Vehicle Dock location .
Leave yourself enough cable so you can easily connect it to the antenna
connector of the dock .
5
Continue with “Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter” on page 37 .
Sport Utility Vehicle (SUV)
1
Feed the antenna cable underneath the rubber weather stripping of the
rear tailgate window/door and route the cable along the rear hatch . Lift
the weather stripping from the opening and tuck the cable inside it, then
replace the weather stripping . Pull the cable out from weather stripping
and route it into the cabin under the interior trim . Avoid hinges or gears
that could crimp or cut the cable .
2
Route the cable through the
SUV’s main cabin area under
the interior trim, towards the
front of the vehicle . Use a blunt
plastic putty knife or similar
blunt tool to lift the plastic trim
just enough to tuck the cable
under underneath . Avoid side
airbag locations on back pillars
and above the doors . Airbag
locations are marked with “SRS”
Vehicle Installation
Summary of Contents for EDGE
