Wireless NVR System User Manual
34
4.9 Alarm
4.9.1 Motion Detection Alarm
Function Description:
When system detects motion detection in the selected area, it will trigger
alarm and output alarm.
Operation Steps:
1.
Right click mouse in your system, choose “System setup” to enter the system setup interface
2.
Choose “Record setup” and click “Video detection”, you’ll enter motion detection alarm setup
interface, as shown in Image.
Figure 40
3.
Set the Sensitivity of motion detection.
4.
Detection is set to be “Motion”, choose the Alarm duration time and select the alarm type.
5.
Set the stream type, detailed operation steps as below:
1) Choose “System setup” - “Channel Setup” - “Video Manage” - “Edit Channel”.
2) Choose “Video Alarm” in the drop-down menu of stream type.
3) Click “Save” to save settings.
6. Click “Apply” to save settings.
7. Area edit allows users to exclude certain areas such as a frequently moving tree.
Tips:
There are five grades of sensitivity: Highest, Higher, Moderate, Lower, Lowest. The higher the
sensitivity, the easier the moving object be detected
There are four ways of motion detection output type
：
Alarm, Buzzer, E-Mail, FTP Upload.
If you choose Alarm as motion detection type, then you’ll need to go to “Record Setup” - “Alarm
Setup” to set the operation mode as “Normally Open”.
