Modules
Setting Up SATA RAID, Optane™ or AHCI Mode 6 - 11
6
RAID Setup (2 * PCIE SSDs) - UEFI Enabled
If you are setting up a RAID using 2 * PCIE SSDs, with the
Windows 10 OS
in-
stalled on one of them, then follow the setup procedure below:
To configure your RAID (Redundant Array of Independent Disks) system in Strip-
ing (RAID 0) or Mirroring (RAID 1) modes (see
Table 6 - 2, on page 6 - 5
) you will
require
two
identical
solid state drives.
You need to setup a RAID before installing your
Windows 10
operating system, and
you will need to prepare the following in order to do so.
==========================================================
• The
Microsoft Windows 10 OS DVD
.
• A connected external DVD drive.
• Two Identical solid state drives.
• The
Device Drivers & Uti User’s Manual
disc.
==========================================================
Before setting up the system you will need to copy a driver folder to a USB flash
drive. This driver folder is included on the
Device Drivers & Uti User’s Man-
ual disc
but
you will need to go to an operable computer and copy the folder to a
USB Flash drive.
Summary of Contents for PRO 17
