OFF POSITION
LIGHTING/HIGH
POSITION
OFF
LOW
HI
OFF
LOW
HI
lighting the burners
LIGHTING WITH FLAME THROWER IGNITION
To light a burner, remove the lid and open the gas isolation or tank valve.
Push and hold the control knob in - this will start the flow of gas. Wait 3 to 5 seconds.
While holding the knob in, turn the knob to the left to the 9 o’clock position
An audible click will sound and the burner will ignite.
The flame will be visible through the port next to the flash tube.
To light the second burner, slowly open that control knob.
NOTE:
PREHEAT YOUR GRIDDLE FOR BEST RESUTS.
Prior to lighting - using a cooking oil that will not smoke, oil the griddle surface to prepare it.
Before cooking turn both burners on medium until your desired temperature is reached. The
extra thick griddle plate holds the heat. If it gets too hot, you will have to wait for it to cool.
MANUALLY LIGHTING THE GRIDDLE.
NEVER
attempt to re-light a burner without waiting 5 minutes for any residual gas to dissipate.
At arms length, using a long stem match or long reach lighter next to a flash tube in the grease
trough (see diagram below). There is one for each burner.
Slowly rotate the knob for that burner 1/4 turn to the left to the HI position.
If the burner will not light after several attempts - Call for service -
Observe Flame Here
Light Here
26
