6
6.2 Main CPU software burn-in need write-protection, below is the setting:
6.2.1 If use ALL - 100:
a) Enter into
AUTO
interface, select
Config.
Make sure
Config
must be selected
when burn-in
Flash
.
b) Click
Config Setting
, set
Protect
item to
All Protect
, set
SRWD
item to
Enable
,
then click OK, write-protection setting is finished. Every time when exit from
ALL-100
burn-in program, if want to enter again, the above two steps’ setting must be done
again.
If SRWD item is not available, please upgrade ALL-100 burn-in program.
6.2.2 If use Mstar on-line burn-in tool
6.2.2.1 Open the tool, click
Device
.
a)
Select
WP Pin pull to high during ISP
b) Select
New Setting Below
.
c) Select
Status Register Bit2 Bit3 Bit4 Bit7
. Now write-protection setting is
finished.
6.2.2.2 When do on-line upgrade, firstly make sure to confirm write-protection is set
correctly.
Summary of Contents for LC-19HU56S
