XOCECO PH-50HU31, Service Manual

1 

Safety precautions 

Please read the “Points for attention for the Maintenance & Repair of PDP” and “Criterion for 
Identifying the Defects on Screen” as below, before inspecting and adjusting the TV set. 
 

1. “Points for attention for the Maintenance & Repair of PDP” 

To avoid possible danger, damage or jeopardy to health and to prevent PDP screen from new 
damage, the maintenance people must read the following carefully. If they ignore the following 
warnings, there will be deathful risks: 
1.1 Screens vary from one model to another and therefore not interchangeable. Be sure to use the 
same type of screen in the replacement. 
1.2 The operation voltage is approximately 350v for PDP module (including screen, driving circuit, 
logic circuit and power module). If you want to conduct maintenance work on PDP module when the 
set is in normal operation or just after the power is off, you must take proper measures to avoid 
electric shock and never have direct contact or touch with the circuitry of the working module or 
metal parts. That’s because within a short time relatively high voltage still remains on the capacitor 
of the driving part even after the power is off. Make sure to begin relevant maintenance operation at 
least one minute after the power is off. 
1.3 Don’t apply on the module any power supply that is higher than the specification. If the power 
supply used deviates from the value given in the specification, there might be a possibility of leading 
to fire or damage to the module.   
1.4 Never have operation or mounting work under unsuitable environment such as areas in the 
vicinity of water (bath room, laundry, water chute of kitchen), sources of fire, heat-radiation parts or 
direct exposure to sunlight. Otherwise there will be kickbacks. 
1.5 In case foreign substances such as water, liquid, metal slices or others fall into the module 
carelessly power must be cut off immediately. Keep the module as it is and do not move anything on 
the module. Otherwise it might be possible to contact the high voltage or cause shock short circuit 
so that it may lead to fire or electric shock. 
1.6 If there is smoke, abnormal smell or sound from the module, please cut the power off     
immediately. Likewise in case the screen doesn’t work when the power is on or during the operation, 
please also cut off the power at once. No more operation in this case.   
1.7 Do not remove or plug its connection wire when the module is in operation or right after the 
power is off. That’s because there remains a relatively high voltage on the capacitor of the driving 
circuit. If there is a need to remove or plug in the connection wire, please wait at least one minute 
after the power is off. 
1.8 Considering the module has a glass faceplate, please avoid extrusion by external force lest it 
should cause glass breakage that may get people injured. Two people are needed in cooperation to 
move this module lest contingency takes place. 
1.9 The complete TV set is designed on the basis of full consideration of thermal dissipation by 
convection, with the round hole on the top for heat emission. To avoid overheat, please do not have 
any covering on the hole during normal operation and never put it in the place where the space is 

Attention: 

This

service manual is only for service personnel to take reference with. Before 

servicing please read the following points carefully.