TelePAD 10A3
7
E
n
g
lis
h
First Steps
Power supply / charging the device
The device can also charge the battery from a USB 2.0 port of a connected computer. Alternatively
use the supplied power adapter to charge your Xoro TelePAD 10A3. Please read the information on
the nameplate of the power supply.
Notes:
•
The charger delivers a stabilized DC voltage of 5V. Operation with non-stabilized voltage can
damage the instrument. Only use the supplied power supply, safe operation and compliance
with all regulations and standards is ensured.
•
Charge the device if possible, prior to when the device prompts you to load the built-in
battery. With regular charging cycles, you conserve the built-in battery and prolong its service
life.
USB ports & Memory Cards
The device has a microUSB 2.0 port. This connector USB devices such as mass storage devices
(USB sticks, hard drives, etc.) or USB input devices (mouse, keyboard, etc.) can be connected . The
device also has a MicroSD memory card slot. The device supports memory cards with a capacity of
up to 32GB FAT / FAT32 format.
Notes:
•
It supports only the file systems FAT/ FAT32 . If a medium is formatted with a different file
system, then this may not be recognized by the device.
•
The USB ports on this device are not suitable for charging other devices with integrated
battery (mobile phones , tablet computers, MP3 players, etc. ) . Notice the specifications on
the type plate with respect to the maximum power output of the USB ports
•
Unfortunately, there are a variety of different SD cards and USB 2.0 storage devices on the
market , so that a fundamental compatibility of all storage media can not always be
guaranteed .
Headphone
The device has on the top a headphone jack. For the use of a commercially available headphones
with 3.5 mm jack is required.
Note:
The built-in speaker on the back is automatically turned off when using headphones.
Screen
The Xoro TelePAD 10A3 are equipped with position sensors. This recognizes the position in which
the device is located and rotates the on-screen content in the correct position. In order to prevent the
rotation of the screen contents, you can use this function in the system settings off. The built-in
display is touch-sensitive (touch screen) and with the fingers (input via virtual keyboard (page 11),
symbols or gesture control) or a suitable pen served.
