Xpand AE125H, User Manual

User Interface

Power LED

Power LED will indicate that emitter is powered and running.

Sync LED 

Sync LED will not only show whether synchronization signal from projector is 
present or not. User can also check the functionality of glasses looking at LED 
through left or right lens; through one it should be bright, through other it should 
be dim.

Push-button 

Reverse Push-button is used to reverse IR sync signal. Although this can be 
achieved in projector’s setting, it is more convenient to do this on emitter itself 
where the user can check the picture with 3D glasses right on the spot.

Troubleshooting

Emitter is connected but 3D glasses do not work:

»

Make sure power adapter is connected properly. Power LED       should be lit.

»

Make sure sync cable is connected properly and that projector is in 3D mode. 
Sync LED       should be lit.

»

Make sure that your 3D glasses are turned ON and that they successfully 
synced with the emitter. Refer to your 3D glasses’ manual for instructions on 
how to sync them with the emitter.

© XPAND, All Rights Reserved. 

www.xpandvision.com

1    

5

3

1    

5