© XPANDVISION, All Rights Reserved.
www.xpandvision.com
Set Your Glasses to Operate in 3D Mode
Set your 3D device to 3D DLP-Link™ mode and turn on the glasses. When the glasses are in
range of your 3D device, they will automatically start to operate in 3D mode.
Battery Low Indication
If the glasses are ON and the LED is blinking every couple of seconds this indicates low battery
level. Glasses will continue to operate normally until the battery is completely discharged.
Battery Charging
»
Step 1: Connect USB charging cable to USB power supply (e.g., computer or wall charger
with USB compliant output).
»
Step 2: Connect charging cable to glasses.
»
Step 3: LED is ON (charging).
»
Step 4: LED turns OFF (fully charged).
»
Charging usually takes 3 hours, when battery is completely discharged.
»
Please, fully charge the glasses prior to the first use.
»
Please note that the glasses can’t be used during charging.
Troubleshooting
The glasses don’t work: Make sure that the glasses are turned on. If problems persist try to turn
the ambient lights off or shade the windows if intensive sunlight is present. Make sure that your
3D device is set to 3D DLP-Link™ mode. Get closer to the screen. Range of the glasses strongly
depends on the used 3D device and/or projection screen.
Attention – Consult Accompanying Documentation
Important Safety Instructions
!
Read these instructions.
!
Keep these instructions.
!
Heed all warnings.
!
Follow all instructions.
!
Do not use this apparatus near water.
!
Clean only with dry cloth.
!
Only use the attachments/accessories included
Battery
The 3D Glasses Battery is not user replaceable.
WARNING, Battery May Explode If Mistreated. Do Not Disassemble, Or Dispose of In Fire.
