© XPAND, All Rights Reserved.
6
www.xpandvision.com
Anti-theft System
Anti-theft System, specifically designed for XPAND Infinity Cinema 3D Glasses, is
optional accessory and is not a part of standard XPAND Infinity 3D Glasses package.
Testing of the glasses
Testing of the glasses prior to distribution to a user can be performed using the AT100
Active Glasses Tester. The AT100 is “ON” if the “ON/OFF” button is pressed and the
red LED is lit. The AT100 is designed to generate a low intensity IR signal that, when
passed within 2 feet (60 cm) of the X101 glasses, causes the lenses to flicker in
response to the IR signal. Both lenses should flicker at a visible rate and in doing so
indicate that the glasses are functioning properly and are ready for distribution. If the
lenses do not flicker, the battery is empty and should be replaced before further use.
The AT100 shuts off automatically after several hours or can be turned off manually.
Handling Instructions
Battery Replacement Guide
The following document is to help you to open the battery compartment in your X103
Infinity 3D Glasses.
Step 1
Insert the tool into the opening of the battery case.
Step 2
Use the inserted tool as a lever – while it’s inserted in the opening of the
battery case, gently push it downwards.
Step 3
If done correctly plastic cover slides out smoothy. Now you can easily remove
it and replace the battery.
Step 4
When covering the lid, put the cover into place in vertical movement. The
cover will smoothly slide into the lid. Click at the end means that the cover has
locked in.
Attention
!
Never
push the tool towards the inner side of the glasses. You will be unable to
uncover the lid, the hook on the cover will however get broken and it’ll be impossible
to really close the lid again.
Changing Ear Handles
If broken or damaged, ear handles can be replaced with new ones.
Step 1:
Unscrew the screw and remove the ear handle.
Step 2:
The new ear handle is inserted into the glasses and tighten the screw back in.
