SPEED SETTING
The fans are factory set to low speed, but have two speed se
�
ngs for di
ff
erent applica
�o
ns. Select either high or low speed
by conne
c�
ng the jumper between the centre and high or low speed pin on the jumper (see Figure E)
C6TS / C6TR Only.
•
To adjust the over-run period turn the control (T) clockwise to increase and an
�
-clockwise to decrease – see Figure D.
C6HTS /C6HTR Only – see
fig
ures D and E.
•
The pre-set humidity opera
�
on is factory set at approximately 75% Rela
�
ve Humidity (RH), but can be adjusted
between 65% and 85% RH by control H.
•
The over-run
�
mer is factory set at 15 minutes but can be adjusted from 30 seconds to 30 minutes by control T.
•
Turn the controls clockwise to increase RH or
�m
e and an
�
-clockwise to decrease.
C6S / C6R Only
•
Operate the fan using the on/o
ff
switch (not supplied). Repeat to switch o
ff
.
C6PS / C6PR Only
•
Operate the fan by pulling and releasing the cord. Repeat to switch o
ff
.
C6TS /C6TR Only
•
Operate the fan using an on/o
ff
switch (not supplied). When the switch is turned o
ff
, the fan con
�
nues to operate for
the set
�
me delay. To adjust the over-run period, turn the control “T” clockwise to increase and an
�
-clockwise to
decrease – see Figure F.
C6HTS /C6HTR Only.
•
- The fan automa
�call
y adjusts to slow changes in natural humidity levels without opera
�
ng the fan.
If the humidity levels increase at a rate slower than 5% RH in 5 minutes, up to the pre-set humidity level, the fan will
not be triggered by humidity. This is to prevent nuisance triggering of the fan. If humidity levels increase quicker than
5% RH in 5 minutes the fan will operate. When rela
�
ve humidity drops the fan con
�
nues to operate for the adjustable
�m
e delay.
•
- Use the external on/o
ff
switch. When the fan is switched o
ff
, the fan con
�
nues to operate for
the adjustable
�
me delay then goes into automa
�c
mode.
All Fans
Re-
fit
the front cover/ba
ffl
e assembly by hooking in the top
fir
st, and then swing the cover down to clip into place.
1. Before cleaning, isolate the fan completely from the mains supply.
2. Remove the front cover/ba
ffl
e assembly by depressing the latch on the underside of the cover
and pulling o
ff
the front cover / ba
ffl
e from the bo
�
om.
3. To clean the front cover/ba
ffl
e assembly, either wipe it with a damp, lint free cloth or wash it
with warm soapy water. Thoroughly dry the front cover and re
fit.
4. Do not immerse the fan in water or other liquids to clean any other parts of the fan.
5. Do not use strong detergents, solvents or chemical cleaners
6. Allow fan to dry thoroughly before use.
7. Apart from cleaning, no other maintenance is required.
This product should not be disposed of with household waste.
Please recycle where facili
�
es exist.
Check with your local authority for recycling advice.
Summary of Contents for C6S
Page 4: ...Wiring and se ng up...
