Chapter 2. Using the iX104AtR
Using the battery
56
iX104AtR User’s Handbook
Using the battery
You can recharge, remove, and replace the battery pack.
Charging the battery pack
If you do not have an external battery charger
Follow these steps to charge the battery while it is installed in the
computer:
1.
Connect a power source, such as an AC adapter or cigarette
lighter adapter, to the power connector on the computer.
If the battery charge is below 90%, the battery begins charging
and the Status LED flashes green. (If the battery charge is higher
than 90%, the battery will not charge, preventing battery
overcharge.)
2.
Check the level of charge. (See “Checking battery power status”
on page 62.)
The charging process continues until the battery charge reaches
100%.
power
connector
Summary of Contents for iX104AtR
