Chapter 1
Getting Started
Preparing the L10 Tablet for First Use
9
Top Side of the XPAD L10
Preparing the L10 Tablet for First Use
This section has steps for setting up the L10 platform for the first use.
Inserting a SIM Card
If your L10 tablet is enabled with Wireless Wide Area Networking (WWAN), you need an activated
SIM card in the SIM card holder to access the cellular data network. The SIM holder is located in the
battery bay of the L10 and can hold one or two Nano SIMs (4FF).
The L10 supports two SIM cards and switching between SIMs is done within Windows. Most people
will need only one SIM. To add or change a SIM, follow these instructions:
1. Shut down and turn off the tablet.
2. Remove the battery if it is in the tablet.
3. Pull out the SIM holder shown above.
4. Put your SIM card into the slot with the contacts facing down ensuring the notched edge
on the card aligns with the notched edge in the holder.
5. Then put the frame back into its port and return the battery to its bay.
See also
Barcode scanner
button
Press to activate the barcode scanner (if installed)
Pen Holder
Holds the long pen when not in use
Barcode scanner
button
Pen Holder
Docking
connectors
SIM card holder
Summary of Contents for iX10101L2
