O
PERATION
Battery
The WS3was designed with a cutting edge extra flat rechargeable Lithium battery with
a 45
hours battery life.
Full charge is achieved in only
2 hours.
This Lithium battery has no memory effect and can therefore be charged at any time, even if it
is already partially charged.
Charge the WS3 headphone by connecting the charger to the DC = plug.
An LED is lit whilst charging. Once full recharged, this light will go out.
Users do not have to fully recharge the unit every time. A 20 minutes recharge will provide
around 6 hours use.
If the battery is completely discharged, it may take up to 10 minutes for the LED to light
up. In this case, the charge system switches to slow charge for the first few minutes to
protect the battery.
If the battery is already fully charged, the green LED will remain off.
! In the event of nonprolonged use of the WS3, it is highly recommended to leave
your battery charged and to occasionally top up in order to avoid a full
discharge.
! Failing to use the correct WS3's charger is likely to damage the WS3
headphone.
On/Off
Quickly and simultaneously press the ± buttons to switch on the WS3. You will hear a beep and the
LED will start flashing.
The same procedure is used to switch off the WS3.
NB:
If you do not want the LED to flash during use, hold down the ± buttons for fifteen
seconds. The LED will not light up, but the headphones will be fully functional.
NB 2:
The WS3 headphones are fitted with an AUTO-OFF system, enabling the headphones to
switch themselves off after five hours of use. This conserves battery life in the event that any
user forgets to manually switch off the device. To carry on using them, just switch them back
on.
O
PERATION
Volume
Set volume with the two ± tactile keys.
The volume setting is memorized for the next time you use the headphone (unless the battery
is completely discharged).
The small black plastic plug with 'XP' logo on the end should be inserted into the headphone
socket to disable the speaker this also stops dust/water ingress.
Choice of channel
You can change the channel at any time by simultaneously pressing the ± buttons for three
seconds. Two beeps will sound and the channel will then be changed.
You can easily find out which input channel is being used:
•
the LED gives off one flash per second on channel 1
•
the LED gives off two flashes per second on channel 2.
Your detector is an ADX250, ADVENTIS 2, GMAXX II or a GOLDMAXX Power :
Modify your detector by using the potentiometer FREQ. SHIFT as follows: CH1
–
up position; or
CH2
–
down position.
For more details please refer to your detector’s instruction manual.
Your detector is an ADX100, ADX200, ADVENTIS, GMAXX or a GOLDMAXX :
Choose the receiver channel of your WS3 wireless headphones based on the transmitter
installed on the circuit board of your detector: CH1 or CH2.
Your detector is an ADX150 :
The channel of your WS3 wireless headphones is CH1.
