https://www.XPOtool.com
Item 61479
Page 5
The Tool Experts
04 2022
-1
Step
3
Select the appropriate sleeve according to the wheel bearing housing diameter, place it on the appro-
priate stepped plate, and select the appropriate bushing depending on the bearing diameter. In the best
case, the bushing is used with the collar pointing towards the bearing for better guidance. If the collar
does not fit easily into the inner diameter of the bearing, the washer can also be inserted with the collar
pointing towards the outside.
Step
4
The individual wheel bearing tool components are now placed on the extracting screw in the following
order:
•
Thrust bearing
•
Pressure sleeve
•
Stepped plate
•
Sleeve
Extracting screw first, insert this unit into the bearing. Now place the other side with the appropriate
bushing, pressure sleeve, and screw-down nut (with the screw-in aid first) on the extracting screw.
Attention!
Check for correct fit before tightening!
Always tighten the extracting screw on the thrust bearing side and counter-hold with a wrench on the
other side.
Once the bearing has been pulled out, the complete unit can be removed from the wheel bearing hous-
ing towards the pull-out sleeve side.
Now dismantle the tool again.
