https://www.XPOtool.com
Item 61974, 61975
Page 4
The Tool Experts
05 2022-1
3.
Position the jack near desired lifting point.
4.
Close the release valve by turning the handle clockwise until it is firmly closed.
Caution:
Use the handle provided with this product or an authorized replacement handle to
ensure proper release valve operation. Do not use an extender on the air hose nor the operating
handle when using to lift vehicles. Lift only on the manufacturer’s recommended lift point and in
accordance with the published guidelines in your vehicle owner’s manual. Always use the jack
stands to support the load.
5.
Hold the handle safely at the end. Pump the handle or press the release valve until the load
touches the ram. To stop the air operation, simply remove the handle of the valve.
Only
acti-
vate/deactivate the hoist control valve by hand.
6.
Raise load to desired height, then immediately transfer the load to appropriately-rated support
devices such as jack stands.
Caution:
This is a lifting device only. It is designed to lift a part of the total vehicle (one wheel
or axis). Always wear safety glasses when using this equipment. Centre the load on the ram
before lifting it. Never work on, under or around load until it is properly supported. Transfer the
load immediately to appropriately rated jack stands.
Do not use this product for any purpose
OTHER THAN that for which it was intended.
It is the owner’s responsibility to keep labels
and instructional material legible and available. Replacement labels and manuals are available
from the manufacturer. Failure to heed these and all other warnings pertaining to this product
can result in sudden loss of lifted load resulting in death, personal injury and/ or property dam-
age.
Lowering
1.
Raise the load enough to carefully remove the jack stands.
2.
Insert handle onto release valve and slowly turn the handle counter-clockwise, but not more
than half a turn. If load fails to lower, carefully transfer the load to another lifting device and jack
stands. Carefully remove the affected jack, then the jack stands. Lower the load again by slowly
turning the release valve no more than half a turn.
Caution:
Be sure all tools and personnel are clear before lowering the load. Dangerous dynamic
shock loads are created by quickly opening and closing the release valve while the load is being
lowered. The resulting overload may cause
hydraulic system failure which could cause se-
vere personal injury and/ or property damage.
3.
After removing the jack from under the load, push the ram and handle sleeve down to reduce
exposure to rust and contamination.
Maintenance
Important:
Use only a good grade hydraulic oil. Avoid mixing different types of fluid and
never
use
brake fluid, turbine oil, transmission fluid, motor oil or glycerine.
Adding oil
1.
With the ram saddle fully lowered and pump piston fully depressed, set jack in its upright level
position and remove the oil filler plug.
2.
Fill until oil is level with the filler plug hole and reinstall the oil filler plug
Changing oil
For best performance and longest life, replace the complete fluid supply at least once a year.
1.
With the ram saddle fully lowered and pump piston fully depressed remove the oil filler plug.
2.
Lay the jack on its side and drain the fluid into a suitable container.
Note:
Dispose hydraulic fluid environmentally friendly in accordance with local regulations.
