https://www.XPOtool.com
Item 62296
Page 7
The Tool Experts
05 2022-1
Lubricating
Loosen the grease cap with a spanner, remove it and fill the grease into the opening.
Figure
6
Figure
7
Commissioning
•
Before starting this device for the very first time, press the primer a few times to supply its
system with fuel (see figure
4).
•
Hold the hand grip with one hand and quickly pull the recoil start with the other until its cable
reaches a length of about 50
cm. Do not let the recoil start rebound freely and instead guide it
back to protect the starter.
•
Open the ventilation once the motor has been started.
Figure
8
Figure
9
Application
•
Let the demolition hammer run at a low speed for the first 2–3
min after starting it to allow the
machine to warm up.
•
Start using the device once the temperature is high enough (according to the required impact
energy) to achieve an ideal starting position and thereby reduce the strain placed on the device
and its parts.
