https://www.XPOtool.com
Item 62680–62682
Page 3
The Tool Experts
05 2022-1
Introduction
Thank you for purchasing this quality product.
To minimise the risk of injury we urge that our clients
take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Safety instructions
Certain tasks and operations must not be performed with this trolley as they might lead to personal injury
or property damage.
•
The transport of persons is not allowed.
•
Do not transport objects above persons’ heads.
•
Loads must be lifted vertically. Diagonal pull must not be performed.
•
Do not attempt to free jammed loads by tearing at them.
•
Do not leave lifted loads unobserved.
•
Do not reach into the moving parts.
•
It is prohibited to use the trolley to tear objects off, loosen, or pull them horizontally.
•
The maximum load capacity of the trolley must not be exceeded.
•
Check the trolley for damage and signs of wear before using it. A damaged trolley must not be
used and must be repaired by qualified personnel before it can be used again.
•
Always make sure the trolley is properly and securely connected to the beam before using it.
•
Check the rollers of the trolley before every use. It is important to inspect the side clearance
between the rollers and the beam.
•
Before using the trolley, always check the screw retention as well as the fastening of the trav-
erse.
•
The personnel intended to operate the trolley must have read and understood the information
and instructions stated within this operation manual and must be familiar with the device before
operating it.
•
Do not wear loose clothing, jewellery or accessories and make sure to keep long hair tied up or
covered by snood-type cap. Loose accessories, clothing, or long hair might get caught in moving
parts and cause severe injuries.
•
Labels and signs depicting safety instructions must not be removed or garbled. All security in-
structions located on the trolley must be kept in readable condition.
Important!
The trolley was designed for manual operation and must not be operated with a motor
or other means such as a drill.
Assembly
1.
Accurately measure the width of the beam, to which the trolley is supposed to be attached to.
2.
Equally attach a number of spacers to the inside of the trolley that causes the wheel flanges of
the rollers to be 6
mm wider than the width of the beam.
3.
Mount the remaining spacers to the outside of the plate assemblies and attach matching nuts
to the suspension bolt.
4.
A minimum of 1
spacer must be place on the inside as well as on the outside of every lateral
plate (Fig.
N).
5.
Loosen the nuts of the suspension pin and straddle the lateral plates to enable the rollers to
effortlessly slide along the beam.
6.
Tighten the previously loosened nuts and make sure they securely rest against the spacers
before attaching a light weight to the trolley to confirm that all the rollers contact the beam. Once
again tighten the nuts and secure them with the help of locking devices.
Attention!
The nuts must be securely fastened before the trolley can be put to use!
