The tip guard
assembly
leaks.
1.
The tip was assembled in-
correctly.
2.
The washer is worn.
1.
Check the tip assembly and
assemble properly
2.
Replace the washer.*
The spray gun
will not spray.
1.
The spray tip or the gun fil-
ter is plugged.
2.
The spray tip is not fully in
the SPRAY position.
1.
Clean the spray tip or gun fil-
ter.
2.
Put the tip in the SPRAY posi-
tion.
The paint pat-
tern is tailing.
1.
The pressure is set too
low.
2.
The gun or the suction filter
is plugged.
3.
The suction tube is loose
at the inlet valve.
4.
The tip is worn.
5.
The paint is too thick.
6.
Pressure loss.
1.
Increase the pressure.
2.
Clean the filters.
3.
Tighten the suction tube fitting.
4.
Replace the spray tip.
5.
Thin the paint.
6.
Refer to Causes and Solutions
for problem C.
* Special repair kits with instructions are available for these procedures.
** Additional parts are available for this procedure.
Daily Maintenance
The only daily maintenance necessary is thorough cleaning and lubricating after usage. Follow
the cleaning and lubricating procedures in this manual.
Extended Maintenance
Some pump parts eventually wear out from use and must be replaced. The following list indicates the
available repair kits for the parts replaced by each kit. However, pump performance is the only reliable
indicator of when to replace wear parts. Refer to the
Troubleshooting
section for more information on
when to use these kits.
https://www.XPOtool.com
Artikel 63003
Seite 25
The Tool Experts
04 2021
-1