https://www.XPOtool.com
Item 63004
Page 5
The Tool Experts
04 2022-1
Use
Filling the tank
1.
Turn the blue screw knob counter-clockwise,
setting it to “extract.” Tighten the screw knob.
2.
Turn the flow direction valve to “extract,” too.
Both regulators must be set to the same mode.
3.
Connect the hose with regulating gun to the oil
transfer device. Connect the other end of the
regulating gun with the 1
m nylon hose.
4.
Connect the device to an air compressor.
5.
Put the hose into the liquid inside the tank to
suck in the oil.
6.
Lock the trigger.
7.
Press the trigger of the regulating gun to begin
sucking in.
Filling the vehicle gear
1.
Turn the blue screw knob clockwise, setting it to
“dispense.” Tighten the screw knob.
2.
Turn the flow direction valve to “dispense,” too.
Both regulators must be set to the same mode.
3.
Connect the hose with regulating gun to the oil
transfer device.
4.
Choose an appropriate adaptor and connect
this with the vehicle. Then connect the regulat-
ing gun to the adaptor.
5.
Connect the device with the compressor and
switch this on. Then lock the trigger.
6.
Press the trigger of the regulating gun to begin
filling.
Tank with scale
The scale on the 6 litres tank
allows easy reading and
checking tank content.
Quick-lock coupling
The quick-lock coupling al-
lows the hose to be discon-
nected easily by pressing it
once.
Safety valve
For safety reasons, pull the
ring of the safety valve after
use to purge excess of air in-
side tank.
Extract/dispense regula-
tor
The pump can be switched
from one mode to the other
via the regulators. The ad-
justments of both regulators
must always match.
Important Note:
Reproduction and any commercial use (of parts) of this operating manual, requires a written permission
of WilTec Wildanger Technik GmbH.
