https://www.XPOtool.com
Item 63080, 63081
Page 4
The Tool Experts
01 2022
-1
•
Do not leave heavy objects hanging for too long as this puts excessive strain on the winch parts
and can lead to an accident.
•
If the steel cable is worn out, only have it replaced by an equivalent cable in a specialist work-
shop.
•
Before starting work, check the functionality of the switches.
CAUTION!
THE ELECTRIC MOTOR OF THE WINCH HAS NO OVERLOAD PROTECTION. IF
LOADS CANNOT BE LIFTED, DO NOT TRY TO LIFT IT FURTHER BUT STOP AND LET THE EN-
GINE COOL DOWN.
Lift limitation
Due to the lift limitation, only a limited distance is possible when lifting or lowering a load. Do not use
this device as a drive switch and never dismantle it.
Brake system of the winch
•
The brake system was set at the factory so that it works safely in the range of the rated power
for lifting. After a long period of use, the braking system can show signs of wear; the brake then
no longer works properly and safely. If you find that the winch no longer achieves its rated
output, ask your dealer to replace the brake disc.
•
This electric winch has safety devices for the start and end of the lift. When a load is lifted to the
end stop, the safety switch is triggered and the motor then stops. The same applies to the low-
ering speed: If it is too fast, the safety switch interrupts the process and the motor stops as well.
The safety device against too quick lowering is located on the side of the engine. There must
still be at least 2
turns of the steel cable on the drum when the safety switch responds. If this is
not the case, being no longer properly adjusted, it must be readjusted by the dealer.
•
All the parts listed above that can easily wear out must be checked at least every 6
months so
that the device continues to function properly and the operator can work safely with it.
Fastening and commissioning
This electric cable winch is equipped as standard with a special clamp mounting system with a special
profile for mounting on square or round pipes.
A = without redirection
B = with redirection
Make sure that the available voltage and frequency match the information on the nameplate. If this is
the case, plug in the power plug. If you use an extension cable, the minimum cross-sections in the table
below must be observed:
Cable length
(m)
Diameter
(
㎜
)
up to 20
1.5
20–50
2.5
A
B
