https://www.XPOtool.com
Item 63368
Page 3
The Tool Experts
06 2022-1
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Safety instructions
•
Keep all protective devices in good condition. Do not modify them in any way.
•
Keep your working area tidy and well illuminated. A cluttered and poorly lit workplace increases
the risk of accidents.
•
Keep children and bystanders away from your work area.
•
Do not use the machine near flammable liquids or gases.
•
Wear appropriate clothing. Always wear suitable protective equipment while working. Do not
wear loose clothing or jewellery. Long hair must be tied back.
•
Always wear safety goggles during operation to prevent flying particles from getting into the
eyes. Wearing normal glasses will not be sufficient.
•
Keep the unit away from humidity and rain.
•
Only operate the device in well-ventilated areas. Ensure suitable dust extraction, e.g., by using
a dust collection system. Always wear an approved respiratory mask, as dust from certain ma-
terials may be harmful to your health.
•
Make sure that all adjusting tools have been removed from the device.
•
Ensure that there are no foreign objects (e.g., nails) in the workpiece.
•
Check before each use whether parts of the machine are damaged or loose. Tighten all loose
connections and have defective parts replaced by a qualified specialist.
•
Do not overload the machine. It works more reliably when used within its recommended param-
eters.
•
Use the device correctly. Any improper use can lead to accidents and injuries.
•
Do not use drill bits that are too long or stick out of the drill chuck. Otherwise, the bits could
bend or break.
•
Do not use the machine with round brushes, cutters, circular saw blades, hole saws, and cutting
blades.
•
Always secure the workpiece with clamps or a vice. Do not use workpieces that are too small
to be securely fastened.
•
Always disconnect the machine from the power supply before carrying out maintenance work
or replacing components.
•
Only use approved accessories. The use of inappropriate accessories can lead to accidents
and injuries.
•
Never leave the machine unattended when it is switched on. Always switch it off and wait until
it has come to a complete stop before leaving the work area.
•
Do not lean too far forward. Ensure a safe stand and keep your balance.
•
Keep the machine regularly maintained and serviced.
