https://www.XPOtool.com
Item 63368
Page 7
The Tool Experts
06 2022-1
Adjusting the laser beam
Untighten the adjusting screw on each laser tube and adjust the device so that both beams intersect at
the point of contact between the drill and work piece. Re-tighten the adjusting screw.
Attention!
When adjusted incorrectly, the batteries might leak and damage the laser light device.
Circuit diagram
The power supply for this machine is single-phase alternating current (AC). The control of the circuit is
shown as below:
№
Name
№
Name
1
Motor
6
Wire connection
2
Motor cord
7
White
3
Green
8
Black
4
Black
9
Green
5
Power switch
10
Power cord
