https://www.XPOtool.com
Item 34121
Page 3
The Tool Experts
04 2022-1
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Safety instructions
•
Familiarise yourself with the user’s manual before using the device. Read it thoroughly and
follow all safety and other instructions to avoid damages and injuries.
•
Only use the device for its specified purpose. Any incorrect use might lead to injuries and/or
damages.
•
This device is not suitable for persons (including children) with limited physical, sensory, or
mental abilities, lack of experience or knowledge, unless they have been instructed and are
supervised by an experience person responsible for their safety and familiar with the device.
•
Children must not use the device and should be supervised when they are near it to ensure that
they do not play with it.
•
Under no circumstances should you direct the device towards your body or other persons’ bod-
ies or animals.
•
The maximum capacity must never be exceeded.
•
Before any use, check all connections and hoses for proper condition.
•
Should the device or hose be damaged, the device must not be used.
Risk of injuries!
•
Only operate the device in well-ventilated areas.
•
Wear appropriate protective equipment (safety glasses, protective gloves, respiratory mask)
when operating the device.
•
Do not use the device near possible sources of ignition (e.g., cigarettes, open flames, etc.).
Paints, thinners, and dissolvents, being highly flammable, must be handled with uttermost care.
Obey the warnings and safety instructions given by the manufacturer of the paint, thinner, or
dissolvent.
•
Clean the device after every use.
•
Only have the device repaired by a qualified person.
•
Never use the device to spray food or chemicals.
•
Never use oxygen, combustible gases, or high-pressure gases as spray gases with this device.
•
Disconnect the device from its air supply before maintaining, repairing, storing it or in case you
want to perform an emergency cut-out or prevent any unauthorised person from using it. It is
advisable to have a ball valve at hand.
•
Do not use dissolvents susceptible to react with aluminium or zinc.
Before using the product
•
Make sure to have received all components of the device and all accessory parts and check
them for damages immediately after unpacking them.
•
To achieve a regular and clean spray pattern, the surfaces to work on must be clean, dry, free
from dust, and free from rust.
Air supply
•
This device requires clean and dry compressed air between 2.5 and 3.5
bar. Normally com-
pressed air contains humidity and other contaminations that might cause inner components of
the device to rust or wear. A filter can remove most of these contaminations, thus prolonging
the service life of the device. Use a filter and pressure regulator as close to the device as pos-
sible.
•
Attention!
All compressed-air lines should be adjusted to 2.5–3.5
bar. Too high or too low an
air pressure might damage the gun and impair the spray performance.
