https://www.XPOtool.com
Item 34121
Page 4
The Tool Experts
04 2022-1
Use
1.
Connect the gun to a compressed-air connection. Make sure that the air pressure suits the
material to be worked on.
2.
Thin the paint in accordance with the manufacturer’s instructions and fill the paint into the paint
cup. Then close the paint cup properly.
3.
Take the gun. Make sure that the compressed-air hoses are not kinked or otherwise blocked.
4.
By pressing the trigger, the air will begin to flow. Slowly pull the trigger backwards to achieve
atomising of the paint.
5.
The spray pattern depends on the distance between the spray nozzle and surface.
•
Slow movements are recommended for small amounts of paint, fast movements for large
amounts of paint.
•
Do not spray arc-shaped patterns and do not pause spraying, as otherwise the paint will not
be spread regularly.
•
To apply fine lines, remove the needle cover and bring the gun close to the surface.
•
Make sure that the distance between the gun and surface stays constant. 15–20
cm be-
tween the device and surface should be kept.
•
Begin moving the device before operating the trigger, stop moving it after releasing the trig-
ger.
6.
Switch off the compressed-air supply and let the pressure off as soon as you do not use the gun
any longer.
7.
Empty the paint cup after work. Drain the paint rests into an appropriate container and dispose
of it properly.
Cleaning and maintenance
•
Empty the paint cup and clean it out with water or dissolvent. Immediately wash out two-com-
ponent spray medium after use.
•
Fill water or dissolvent into the pain cup, then keep the needle holder shut by hand and spray.
Thus, the air will flow backwards into the nozzle, removing all paint rests.
•
It is advisable to spray again without keeping the needle holder shut to allow fresh dissolvent to
come into the paint conduct; then re-wash the dissolvent by keeping the needle cover shut by
hand. Repeat this several times if necessary.
•
Clean all components thoroughly to avoid any deposit.
•
Never clean the nozzle and needle using a wire or another hard object. That would lead to the
device being damaged and becoming inoperable. To clean the device with care, use an ultra-
sonic bath.
•
Never place the entire gun into dissolvent, e.g., thinner. That could destroy the non-metal com-
ponents.
•
After removing the needle, remove the nozzle as well to spare the seats.
Technical specifications
Nozzle diameter
(
㎜
)
0.8
Paint cup capacity
(mℓ)
125
Jet width
(
㎜
)
280
Service pressure range
(
㍴
)
2.5–3.5
Weight
(
㎏
)
0.38
