18
www.xprgroup.com
4.
3
www.xprgroup.com
2.0 MOUNTING
Do not install the device and cabling close to a source of strong electro-magnec fields like radio-transmi ng antenna.
Do not place the device near or above heang equipments.
If cleaning, do not spray or splash water or other cleaning liquids but wipe it out with smooth cloth or towel.
Do not let children touch the device without supervision.
Note that if the sensor is cleaned by detergent, benzene or thinner, the surface will be damaged and the fingerprint can't be entered.
If the biometric reader is installed and used outdoor, the reader MUST be fi ed with the MC-MINI metal cover available in our accessories in order to protect the sensor from
direct rainfall. The operang temperature of the product is between -20ºC - + 50ºC. If the reader is installed in an environment where the temperature can drop below -10ºC
or/and if the sensor could only be exposed to direct sunlight, it is strongly recommended to install the reader inside a third party sealed wall mount box (fi ed with addional
heater if very low temperature) to keep a constant sensor level performance. XPR™ cannot guarantee the funconality of the product if measures and advice before are not
followed.
It is also strongly recommended to use double technology biometric readers when use outdoor to offer first higher security but also the possibility to use different readers
depending on users.
3.0 SPECIFICATIONS
Fingerprint Capacity:
Output:
Push Button Input:
Door Open Time:
Entry Mode:
Programming:
Master/Admin Fingers:
Image resolution:
Backlight ON/OFF:
Buzzer ON/OFF:
Firmware upgrade:
Current Consumption:
Power Supply:
Indication:
Mounting:
IP Factor:
Storage/Operating Temperature:
Storage/Operating Humidity:
Dimensions(mm):
97 templates
1 x Relay (
)
1 A /24V AC/DC
Yes
Pulse (1, 3, 5, 10, 20, 30, 60sec) or Toggle(ON/OFF)
Finger
By scrolling and tapping on the sensor or by keypad
1 Master and 2 Admin Fingers
Up to 508 DPI
Yes
Yes
via
converter and windows application
R 485
S
100 mA max.
9-14 V DC
Tricolor tatus LED and 4 x Programming LEDs
S
Flush mount
IP65
-20°C to +50°C
5% to 93% RH without condensation
x
x
92
51
25
B100-SA
1.
Cable
Ø6.0(3NoS)
30m
m
5mm
2.
3 (3 x 30mm)
3.
1 (M3 x 6mm)
MC-MINI
Output:
Push Bu on Input:
Door Time:
Backlight ON/OFF:
Buzzer ON/OFF:
Current Consumpon:
Mounng:
IP Factor:
Operang Temperature:
Dimensions:
1 x Relay (2A/24V AC/DC)
1
Pulse (1 to 60sec) or Toggle (ON/OFF)
Yes
Yes
60 mA
surface mount
IP40 (indoor use only)
-20°C to +50°C
92 x 51 x 25
RTT
S
DINB100-SA
PECIFICATIONS
S
DINRTT
PECIFICATIONS
