Function
Button
Lock the doors and arm the factory alarm.
*
Unlock the doors and disarm the factory alarm.
* ö
Open the trunk (hold button for at least 4 seconds).
Panic ON (hold button for at least 4 seconds).
Panic OFF
Start the vehicle.
Stop the vehicle.
Ö
Set car to idle mode when it is already running.
Open and close the sliding door (driver side).
**
Open and close the sliding door (passenger side).
**
Cold Weather Start feature (see page 9 for more information).
Remote Valet feature.
Parameters
Settings
Button
Display/Remarks
Lock
Unlock
Enabled
Disabled
Enabled
Disabled
Upon "Status" command
Upon any command
Never
The back light shuts off.
Number of vehicles
1 - 4 (Default setting: 2)
1 2
3 4
The display lights up for
3 seconds.
Legend:
DISPLAYED ICON (BLACK)
;
MASKED ICON (GRAY)
;
DEFAULT SETTING (BLUE)
.
Keyboard un/lock
Mute
Status confirmations
Back light
Refer to the vehicle user manual for more information on confirmations emitted by
your vehicle (i.e. the horn and parking lights). These confirmations are different for
each vehicle, depending on which module/firmware is used.
Note that the 1-way transmitter is automatically programmed.
Programming the Remote Control Features
To access the 2-way remote control programming mode, press the “
P
” button located on
the back of the remote and hold it for 5 seconds. The remote beeps once to indicate
entering programming mode.
/ 1
BEEP
/
2
BEEPS
1
BEEP
2
BEEPS
/ 1
BEEP
Using your 1-Way Remote Control
Page 6
+
+
/
2
BEEPS
+
+
+
2-Way LED & LCD Remote Start Kits
Rev.: 20091218
© 2009 Directed Electronics. All rights
Model: CHRSALL RS-CHLED & RS-CHLCD
