Page 7
*
Commands followed by an asterisk (*) apply only to modules equipped with a
security system.
**
Only accessible with Chrysler Town & Country 2008-2010, Dodge Grand Caravan
2008-2010, and Volkswagen Routan 2009-2010.
Ö
This command terminates the runtime, panic mode and alarm status (only if the
factory alarm trigger monitoring feature is supported by the firmware).
ö
Temporary valet mode if activated a second time during rearming delay.
Ê
Start confirmation can take a few seconds except if the engine is already running.
Legend: Displayed icons (black); Hidden icons (gray)
Refer to the vehicle user manual for more information on confirmations emitted by
your vehicle (i.e. the horn and parking lights). These confirmations are different for
each vehicle, depending which Bypass is used.
Convenience
Security
Lock the doors and arm the factory alarm.
*
Unlock the doors and disarm the factory alarm.
* ö
Open the trunk (hold button for at least 4 seconds).
Panic ON (hold button for at least 4 seconds).
Panic OFF
Start the vehicle.
Stop the vehicle.
Ö
Set car to idle mode when it is already running.
Open and close the sliding door (driver side).
**
Open and close the sliding door (passenger side).
**
Cold Weather Start feature (see page 9 for more information).
Remote Valet feature.
Status request.
Vehicle selection (hold button for at least 1.5 seconds.)
Confirmations
Sent by Rem ote Control
Function
Button
This button is located on the
back of the remote.
Ê
/
/
+
+
+
Using your 2-Way Remote Control
+
+
Understanding the Confirmations Emitted by the 2-Way Remote
The LCD displays the vehicle status at all time, the display is refreshed on
every transmission or when the status of the vehicle changes pertaining that
the “Status confirmation” function is enabled. The display shows the last
confirmation received.
2-Way LED & LCD Remote Start Kits
Rev.: 20091218
© 2009 Directed Electronics. All rights
Model: CHRSALL RS-CHLED & RS-CHLCD
