1
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module Press
hold the rogramming
.
and
p
button, then connect the 14-pin harness to the module.
10-pin
D2D
1
st
12-pin
14-pin
2
nd
4
th
3
rd
Warning
gainst
xecuting a Hard Reset!
A
E
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings (such
as
and D2D options) may have to be reconfigured. See the
section of this guide.
RFTD
Feature & Option List
2
Solid
&
Release
3
Release the programming button. The
turns
solid red.
LED
ON
Module Reset
Hard Reset
2
&
&
1
Wait 3 seconds until the
orange then release the
LED turns
solid
ON
p
The
turns
solid red.
rogramming button.
LED
ON
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module Press
hold the rogramming
.
and
p
button, then connect the 14-pin harness to the module.
10-pin
D2D
1
st
12-pin
14-pin
2
nd
4
th
3
rd
A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed
to the module using the web config tool will not be affected.
Page 9
Solid
Release
Solid
Solid
Flashes
&
Wait 3 seconds until the
orange
ait
LED turns
solid
, and w
10 more seconds
ON
until the
and
LED starts to flash orange
red.
Rev.: 20 70622
1
Platform: DBALL2
Firmware:
HK7 Remote Start Ready
Installation
(RSR)
© 201 Directed.
7
All rights reserved.
