Page 2
The RKE9 kit is a complete remote start solution with up to 3,000’ of range*, which includes a 1-way transmitter or a 2-
way LED transmitter/receiver, and an all-in-one mobile integration module.
* Range based on line of sight, unobstructed testing in ideal conditions. Actual range will vary due to local conditions
including but not limited to environment, terrain, physical obstructions, vehicle location and orientation, interference and
other possible impediments.
Government Regulations
Taking Inventory of the RKE9 Kit
1-way remote start kit
§
§
§
§
§
§
1x FM-TW-130 Antenna.
2x TF01-1501BK 1
.
1x A001-SH001-C Harness (HW-C4) Interconnect Cable
SH/SR (4-pin)..
1x XL202-HDR Keelog and XRT RF to DATA interface.
1x XK09-C Multi CAN door lock and override module.
-way Transmitter
1x CHTH1-C T-Harness (CAN Type).
2-way LED remote start kit
§
§
§
§
§
§
§
1x FM-TW-130 Antenna.
1x TF01-1501BK 1-way Transmitter.
2x TF04-A3503BK 2-way Tranmistter/Receiver.
1x A001-SH001-C Harness (HW-C4) Interconnect Cable
SH/SR (4-pin)..
1x XL202-HDR Keelog and XRT RF to DATA interface.
1x XK09-C Multi CAN door lock and override module.
1x CHTH1-C T-Harness (CAN Type).
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a
no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful
interferences to services authorized by IC. In addition, the user of this device must accept any radio interface that may be
received, even if this interference could affect the operation of the device.
Warning! Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this device.
§
§
§
§
1-way & 2-way LED Remote Start Kits
Rev.: 20101109
Model: RKE9
© 2010 Directed Electronics. All rights reserved.
The Mobile Integration Systems
