Page 6
Advanced Features: Installation Programmable Options
The remote car starter was designed with flexibility in mind. With its program¬mable options, this unit can single-handedly
control nearly any electrical system in your vehicle.
The programming of your system should be left to a professional. Changing any one of the settings may affect
the operation of your Remote Car Starter.
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user leaves the vehicle: the
unit will take over the vehicle and keep it running for 60 seconds (or until it is shut down by remote control), then shut
down the engine.
To set the system to Turbo Mode:
1. With the engine running, make sure to release the brake pedal and press the LOCK, UNLOCK or
button on the
transmitter until the parking lights come ON.
2. Remove the ignition key from the ignition switch. The engine will continue running.
3. Exit the vehicle and close all doors, hood and trunk.
4. Press the
button; this will lock the doors, and confirm that the vehicle is in Turbo Mode.
5. The engine will shut down after 60 seconds.
Controls the driver sliding door.
Press the
and LOCK buttons once to open the driver sliding door, and a second time to
Caution:
Turbo Mode
AUX 1
close it.
Controls the passenger sliding door.
Press the
and UNLOCK buttons once to open the passenger sliding door, and a second time to close it.
AUX 2
Vehicle Status Request
The status request feature allows the user to see the status of the vehicle - i.e.: if the doors are locked or unlocked or how
much time is left in the run time cycle. The following charts (Tables 1, 2 and 3) indicate the confirmation sequences.
To retrieve the vehicle status:
Press and release the
button then press and release the
button (there will be a beep). The transmitter will then
flash the corresponding sequence of LEDs depending on the vehicle’s status.
If the engine is NOT running
If the engine IS running under a remote start (if the doors are locked) or (if the doors are unlocked).
The status request feature is retrieved by a sequence of flashes, which denote if the vehicle’s doors are locked or
unlocked.
§
§
Status Request When the Engine IS NOT Running
STATUS
SEQUENCE
LOCK
UNLOCK
TRUNK
START/STOP
Beep(s)
Lock
3 flashes
X
X
X
1
Unlock
X
3 flashes
X
X
2
1-way & 2-way LED Remote Start Kits
Rev.: 20101109
Model: RKE9
© 2010 Directed Electronics. All rights reserved.
The Mobile Integration Systems
