37
8. ENGINE & CLUTCH
Pull the clutchbell away from the clutch shoe and
measure distance B as indicated.
These shims are used to
adjust clutchbell endplay.
A
Measure endplay with this
bearing installed
Pull
Install the clutchbell, outer ball-bearing (small),
and thrustbearing assembly on the engine
crankshaft. DO NOT install the inner ball-bearing
or internal shims.
Push the clutchbell onto the clutch shoe and
measure distance A as indicated.
Push
B
The clutch gap is A - B;
the correct gap is 0.6-0.7mm
If the clutch gap is greater than this, you can
easily calculate the thickness of shims required
to set correct gap:
Thickness of shims required (in mm) = A-B-0.7
Apply shims on crankshaft to set endplay to
0.05-0.15mm
(1) ADJUSTING THE CLUTCH GAP
ENDPLAY SHIMS
CLUTCH GAP SHIMS
These shims are used to adjust clutch gap.
To measure the clutch gap
(0.6~0.7mm) you can also use
HUDY Flywheel Tool #182010
➊
➋
➌
➊
➋
DO NOT INSTALL
this bearing when setting clutch gap.
INSTALL
this bearing when setting endplay.
(2) ADJUSTING THE ENDPLAY
ø10mm
ø5.2mm
ø9.8mm
ø5.0mm
Degrease this bearing with standard bearing
cleaner, and then lubricate with light bearing oil.
IMPORTANT
NOTE ORIENTATION
Insert
CLUTCH GAP SHIMS
here
For example, using the values A=5.5mm,
B=4.5mm
Shim thickness = 5.5-4.5-0.7=0.3mm
Place shims on the small collar, outside the
thrustbearing assembly.
Insert ENDPLAY SHIMS here
(approximately 0.7~1.0mm)
BEARING
GREASE
BEARING OIL
GRAPHITE GREASE
338584
S 5x7x0.2
338585
S 5x7x0.3
338586
S 5x7x0.5
930150
BA 5x10
930508
BB 5x8x2.5
359050
BB 5x10x4
908312
SCH M3x12
5x10x4mm
18
23
5x8x2.5mm
To tighten the pinion gear, use pinion tool.
OIL
Summary of Contents for 2016 RX8
Page 1: ...1...
