26
FRONT SUSPENSION
901303
SB M3x3
0mm
Wire should be flush
with end of pivot ball.
The alu ball end must be parallel with the
upper arm in order to prevent the ball end
from touching the upper arm when the
suspension is lifted up.
NOTE ORIENTATION
Set the bar into the center, remove the play in the
bushings, and tighten the set-screws fully.
VIEW
CENTER
2x
When the bars are set, verify that both sides move at the same time. If they do,
the bars are set up correctly. If not, make sure that both downstops are the same
and that the bar wire is flat. If the sides still do not move at the same time, adjust
the length of the bar holders.
DETAIL
DETAIL
DETAIL
DETAIL
Summary of Contents for NT1
Page 1: ...1...
