15
TOE-IN
TRACK-WIDTH
WHEELBASE
ROLL CENTER
ANTI-SQUAT
PRO-SQUAT
3x6x1mm
903306
SFH M3x6
NOTE ORIENTATION
903306
SFH M3x6
ECCENTRIC BUSHINGS HAVE TWO DIFFERENT OFFSETS FROM THE CENTER
Middle position = 0.5 mm or 0.5° from center
Outer position = 1mm or 1° from center
The XRAY rear alu lower suspension holders provide even greater range of adjustment for the rear suspension. Using different combinations of eccentric bushings, fine adjustment of rear
squat, rear toe-in, rear roll center, and rear track-width can be obtained. For more information about the influence of rear squat, rear toe-in, rear roll center and rear track-width on car
handling, please refer to HUDY Set-up Book (#209100).
Marked
“RR”
Composite eccentric bushings
INITIAL SETTING
1
1
0.5
0.5
0
Composite eccentric bushings
INTIAL SETTING
1
1
0.5
0.5
0
REAR
SUSPENSION
FRONT SUSPENSION
#303718-O ALU 2-PIECE SUSPENSION 0.25
ECCENTRIC HOLDER STAND
Marked
“FF”
3. FRONT & REAR SUSPENSION
303129
SHIM 3x6x1
3x6x1mm
L=R
#307217
TITANIUM SUSPENSION
PIVOT PIN (2)
L=R
#107633 HUDY Arm Reamer 3.0mm
It is extremely important that the arms move freely
on the pivot pins. If they do not, use the Arm Reamer
(3.0mm) to slightly resize the holes in the arms.
#303721
BRASS REAR 1-PIECE SUSPENSION
HOLDER - (RR)
#303722-O
ALU REAR 1-PIECE SUSPENSION HOLDER
- RR - LOW
#303716-O ALU 2-PIECE SUSPENSION HOLDER - RIGHT – LOW
#303717-O ALU 2-PIECE SUSPENSION HOLDER - LEFT – LOW
#303714 BRASS 2-PIECE SUSPENSION HOLDER - RIGHT
#303715 BRASS 2-PIECE SUSPENSION HOLDER - LEFT
#302712-O
ALU FRONT 1-PIECE
SUSPENSION HOLDER (FF-LOW)
#302711
BRASS FRONT 1-PIECE
SUSPENSION HOLDER - (FF)
Summary of Contents for T4F
Page 1: ......
