16
903306
SFH M3x6
303129
SHIM 3x6x1
TOE-IN
TRACK-WIDTH
WHEELBASE
ROLL CENTER
ANTI-DIVE
KICK-UP
For better stability and to make the car easier to drive, optional #302190 and #303190 graphite stiffeners may be used on the suspension arms. Using only 4 screws, each graphite stiffener can be installed
or removed which will completely change the characteristics of the car. Stiffeners may be used independently at front and/or rear.
IMPORTANT!
Install/remove stiffeners equally on left & right sides.
2.5x6mm
#302190
GRAPHITE FRONT LOWER ARM PLATE 1.6MM (2)
#303190
GRAPHITE REAR LOWER ARM PLATE 1.6MM (2)
2x
2x
All possible mounting
alternatives of eccentric bushings
3x6x1mm
3x6x1mm
2.5x6mm
ECCENTRIC BUSHINGS HAVE TWO DIFFERENT OFFSETS FROM THE CENTER.
Middle position = 0.5 mm or 0.5° from center
Outer position = 1mm or 1° from center
The XRAY front alu lower suspension holders provide even greater range of adjustment for the front
suspension. Using different combinations of eccentric bushings, fine adjustment of front anti-squat, front
kick-up, front toe-in, front roll center, and front track-width can be obtained. For more information about
the influence of front anti-dive, front kick-up, front toe-in, front roll center and front track-width on car
handling, please refer to HUDY Set-up Book.
Composite eccentric bushings
INITIAL SETTING
1
1
0.5
0.5
0
Composite eccentric bushings
INITIAL SETTING
1
1
0.5
0.5
0
FRONT SUSPENSION
3. FRONT & REAR SUSPENSION
#307217
TITANIUM SUSPENSION
PIVOT PIN (2)
It is extremely important that the arms move freely
on the pivot pins. If they do not, use the Arm Reamer
(3.0mm) to slightly resize the holes in the arms.
L=R
#107633 HUDY Arm Reamer 3.0mm
Summary of Contents for T4F
Page 1: ......
