13
ROLL CENTER ADJUSTMENT
The roll center can be adjusted by adding or
removing shims from beneath the aluminum pivot
mounts.
LOWER ROLL CENTER
(INITIAL SETTING - NO SHIMS)
will give more
traction and increase chassis roll.
HIGHER ROLL CENTER
(adding shims)
will increase steering by making
the car rotate more on-and off-power
IMPORTANT! Always use same shim thickness on
both sides of BOTH aluminum holders
Do not use shims for
initial setting.
#303122 & 303123 shims are
NOT INCLUDED in the kit.
Do not use shims for
initial setting.
NOTE ORIENTATION
1mm
1mm
2mm
2x
2. REAR SUSPENSION
Do not tighten fully,
pivotballs must move freely.
Do not tighten fully,
pivotballs must move freely.
902258
SH M2.5x8
902256
SH M2.5x6
THREAD LOCK
PIVOT MOUNTING ALTERNATIVE
REARWARD:
(INITIAL SETTING)
Pivot mounted in rearward chassis holes, and 1mm shim used under the pivot ball.
The rearward pivot mounting position gives the most steering and most free rear end.
Recommended for high-traction conditions such as US black carpet.
FORWARD:
Pivot mounted in forward chassis holes, with 3mm shims under the pivot ball. The
forward pivot mounting position gives a good balance between front and rear traction.
Ensure free,
smooth movement
Tighten the screw enough
to remove excess play, while
ensuring that the pod plate can
turn freely.
303122
SHIM 3x6x1
303122
SHIM 3x6x1
303123
SHIM 3x6x2
303123
SHIM 3x6x2
Summary of Contents for X10 Link
Page 1: ......
